Setting stones in metal clay: fireable stones that survive the kiln and tolerances that work

You can set the stone before sintering (the clay shrinks and hugs it — the easiest setting in the world) or afterwards, as in classic jewelry. The key is choosing the right stone and giving the seat just the right clearance in the 3D design.

Which stones survive sintering

With a torch, better not to fire stones in place: thermal shock is far greater than in a kiln with a ramp. Stone in place = kiln.

Seat tolerance

The seat must be slightly larger than the girdle (the stone's widest outline): with +0.1 mm per side the stone drops in without forcing and, as the clay shrinks, the metal grips it. If the seat is exact, it won't go in; too loose and it rattles before firing.

ElementRecommended measure
Seat clearance+0.1 mm per side over the girdle
Depth (flush setting)girdle 0.3–0.5 mm below the surface
Prongs (metal clay)≥ 0.9–1 mm thick (fatter than in casting)
Bezel wall≈ 0.8 mm
Light hole~60% of the stone's diameter, all the way through

The light hole is not decorative

The through-hole under the stone does three jobs: it lets light through (the stone sparkles instead of going dull), it houses the pavilion (the lower point), and it lets you clean and push the stone out if needed. Its cousin, the azure cutter — a conical window from the inner face — also saves metal, which in silver you notice in the wallet.

Flush, prongs or bezel: which to choose in metal clay

In the Menros editor, all three settings are generated with these tolerances already applied: you pick stone, size and setting, and the seat, light hole and prongs come out exact in the STL — pavé included.

And remember the shrinkage

The seat shrinks with the rest of the ring. If you design at final size and scale the master (calculator here), the master's seat is automatically larger and returns to spec when sintered — one more reason to design digitally instead of carving by eye.

Design a ring with a stone →